TTYredirector Knowledge Base

Category » Modem Servers

There were 3 articles found in this category:

1. What are the guidelines for configuring a Cisco server to be a modem server?
   Cisco IOS version 12.0(9) or greater is required. Cisco recommends at least 12.1(8). Upgrade information is available on the Cisco web site. The IOS configuration needed for TTYredirector goes under the 'lines' section of the configuration file. See below: line "begin" "end"! replace "begin ...
2. How do I send DTMF signals through a Cisco digital modem?
   Cisco routers with digital modems require that an "X" character be placed in front of any DTMF data (dual tone multi-frequency) that is sent in a dial string after a phone number. For more information see: http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/5300/sw_conf/sw_ports/ ...
3. How do I configure a Patton 29xx RAS server to work with TTYredirector?
   Page 111 of the Patton Administrator's Reference Guide shows the settings for allowing outbound calls. Make the following changes in the Dial Out window on your Patton server: Set the TCP Port to: 7000 Set the TCP Type to: Telnet Set Restrict to LAN to: Disable Set Login Technique to: None